Hyundai Accent

Repair and car operation



Hyundai Accent
+ 1. Maintenance instruction
+ 2. Engine
+ 3. Greasing system
+ 4. Cooling system
+ 5. Control, decrease in toxicity
+ 6. Fuel system
+ 7. Ignition system
+ 8. Coupling
- 9. Transmission
   - 9.1. Mechanical transmission
      9.1.1. Specifications
      9.1.2. Check of level of oil
      9.1.3. Replacement of transmission oil
      9.1.4. Replacement of an oil sealing ring of a power shaft
      9.1.5. Replacement of a cable of a drive of a speedometer
      9.1.6. Removal and transmission installation
      9.1.7. Transmission repair
      9.1.8. Gear shifting mechanism
      9.1.9. Hydraulic drive of coupling
      9.1.10. Gear shifting lever
   + 9.2. Automatic transmission
+ 10. Axes and power shafts
+ 11. Suspension bracket
+ 12. Steering
+ 13. Brake system
+ 14. Body
+ 15. Central air
+ 16. Electric equipment
+ 17. Appendix
+ 18. Electroschemes
Heavy Metal & Reflected



9.1.9. Hydraulic drive of coupling

1–hose of a drive of coupling;
2–tube of a drive of coupling;
3–main cylinder of coupling;
4–coupling pedal.

Removal

PERFORMANCE ORDER
1. Turn out the union of pumping and merge brake liquid from a hydraulic drive of coupling.
2. Remove шплинт, a washer and a pin with a head and an opening under шплинт.
3. Disconnect a hydraulic tube from the main cylinder of coupling.
4. Turn out a bolt of fastening of the main cylinder of coupling.
5. Remove clips of the hydraulic line of coupling.
6. Holding from a provorachivaniye a nut on a hose of a drive of coupling, unscrew a nut on a tube.
7. Remove a clip of fastening of a hose of a drive of coupling and remove a hose from an arm.
8. Remove the hydraulic line of a drive of coupling.
9. Disconnect a tube from a coupling hose.

Check

PERFORMANCE ORDER
Check a hose and a tube of a hydraulic drive of coupling on lack of cracks and damages.

Installation

PERFORMANCE ORDER
1. Connect a coupling tube from a coupling hose.
2. Temporarily, by hand, tighten nuts of fastening of a hose and a tube of a wire of coupling then tighten them the demanded moment of an inhaling.

Inhaling moment: 13–17 N • m

3. Establish the hydraulic line of a drive of coupling and fix clips.
4. Establish the main cylinder of coupling.
5. Before installation grease the plug, a pin, a washer and a pin with a head and an opening under шплинт.

Greasing: J310a, NLGI No. 2

6. Establish a pusher on a coupling pedal.
7. Fill in liquid in a coupling tank.
8. Remove air from hydraulic system of a drive of coupling