Hyundai Accent

Repair and car operation

Hyundai Accent
+ 1. Maintenance instruction
+ 2. Engine
+ 3. Greasing system
+ 4. Cooling system
+ 5. Control, decrease in toxicity
+ 6. Fuel system
+ 7. Ignition system
+ 8. Coupling
+ 9. Transmission
- 10. Axes and power shafts
   10.1. Specifications
   10.2. Power shaft
   10.3. A power shaft with CV JOINTS ball and type Birfield
   10.4. A power shaft with Birfield CV JOINTS and tripoidny type
   10.5. Rotary fist and nave of a forward wheel
   10.6. Back axis
   10.7. Search and elimination of malfunctions
+ 11. Suspension bracket
+ 12. Steering
+ 13. Brake system
+ 14. Body
+ 15. Central air
+ 16. Electric equipment
+ 17. Appendix
+ 18. Electroschemes

10.2. Power shaft

1–lock ring;
2–power shaft;
3–rack of a forward suspension bracket;
4–rotary fist;

5–brake disk;
6–nut, 220–260 N • m;
7–bottom lever.

Removal

PERFORMANCE ORDER

1. Lift the car, fix on support and remove a forward wheel.
2. Turn out a nut of fastening of a power shaft to a nave of a forward wheel.
Prevention When weakening a nut of fastening of a power shaft to a nave press a brake pedal to prevent provorachivany wheels and a power shaft.
3. Merge transmission liquid from a transmission.
	4. A kapron hammer beat out a power shaft from a nave of a forward wheel. If the power shaft densely sits in a nave of a forward wheel, spray propitochny aerosol solvent on area шлицов and then repeatedly screw a nut with a fillet so that it settled down flush with a shaft end face. Striking on a nut with a brass hammer, beat out a power shaft from a nave.
5. Reject outside a rotary fist and get a power shaft from a nave of a forward wheel.
	6. Insert mount between the internal CV JOINT of a power shaft and a transmission and easy blow on mount take a power shaft from a transmission.
	Prevention Opirayte mount on edges of a case of a transmission. Do not insert mount very deeply not to damage an oil sealing ring. Do not pull for a power shaft as hinges of equal angular speeds will be thus damaged.
7. Get a power shaft from a transmission.
Prevention Establish instead of power shafts special caps in order that dirt did not get to a transmission. Each time at removal of a power shaft replace a sealing ring of differential.

Check

PERFORMANCE ORDER

1. Check protective covers of CV JOINTS of a power shaft on absence of damages and rubber hardening.
2. Check spherical hinges on lack of wear.
	3. Check shlitsa at end faces of a power shaft on lack of wear and damages.

Installation

PERFORMANCE ORDER

1. Grease a working edge of an oil sealing ring of differential.
2. Establish a new lock ring on the internal end of a power shaft. A push insert a power shaft into a transmission, thus a cut of a lock ring should settle down from below.
3. After installation pull a power shaft outside and be convinced that it is reliably fixed by a round clip.
	4. Establish a washer under a nut of fastening of a power shaft to a nave the convex party directed outside, as is shown in drawing.