Hyundai Accent

Repair and car operation


Hyundai Accent
+ 1. Maintenance instruction
+ 2. Engine
+ 3. Greasing system
+ 4. Cooling system
+ 5. Control, decrease in toxicity
+ 6. Fuel system
+ 7. Ignition system
+ 8. Coupling
+ 9. Transmission
+ 10. Axes and power shafts
- 11. Suspension bracket
   11.1. Specifications
   11.2. Bottom lever of a forward suspension bracket
   11.3. Replacement of the plug of the bottom lever
   11.4. Replacement of the plug (G) of the bottom lever
   11.5. Forward stabilizer of cross-section stability
   11.6. Rack of a back suspension bracket
   11.7. Replacement of the plug of the back longitudinal lever of a back suspension bracket
   11.8. Replacement of the plug of the back cross-section lever (And and In) a back suspension bracket
   11.9. Back stabilizer of cross-section stability
   11.10. Corners of installation of forward wheels
   11.11. Adjustment of a convergence of back wheels
   11.12. Wear of tires
   11.13. Antisliding chains
   11.14. Wheel palpation
   11.15. Tightening of nuts of fastening of a wheel
   11.16. Shift of wheels
   11.17. Check of withdrawal and course instability of the car
   11.18. Care of disks from an aluminum alloy
   11.19. Search and elimination of malfunctions
   11.20. Diagnostics of wear of tires
+ 12. Steering
+ 13. Brake system
+ 14. Body
+ 15. Central air
+ 16. Electric equipment
+ 17. Appendix
+ 18. Electroschemes





11.5. Forward stabilizer of cross-section stability

 Removal
PERFORMANCE ORDER
1. Remove a forward wheel.
2. Remove draft of the stabilizer.
3. Remove an arm of the stabilizer and the plug
4. Remove a back support of the engine.
5. Remove the stabilizer of cross-section stability.

Check
PERFORMANCE ORDER
1. Check the stabilizer of cross-section stability on absence of loss of elasticity and damages.
2. Check a condition of all bolts.
3. Check a protective cover of draft of the stabilizer on lack of cracks or damages.
4. Check a torque which is necessary for putting for a provorachivaniye of a pin of the spherical hinge of draft of the stabilizer.

If there are cracks in a protective cover, replace it and add greasing in the hinge.

Several times shake here and there a pin of the spherical hinge of draft of the stabilizer.

Torque: 1,7–3,2 N • m

If the torque exceeds admissible values, replace draft of the stabilizer.

If the torque is much lower than admissible value, the spherical hinge can be reused, if it is not got jammed and has no excessive люфта.


Installation
PERFORMANCE ORDER
1. Establish the plug on the stabilizer of cross-section stability.
2. Level an arm in relation to the plug. Be convinced that the arm reliably covers the plug.
3. Temporarily fix an arm of the plug and establish the plug on the second party of the stabilizer.
4. Fix draft of the stabilizer a wrench with an open pharynx on 14 mm and screw самоконтрящуюся a nut.