Hyundai Accent

Repair and car operation



Hyundai Accent
+ 1. Maintenance instruction
+ 2. Engine
+ 3. Greasing system
+ 4. Cooling system
+ 5. Control, decrease in toxicity
+ 6. Fuel system
+ 7. Ignition system
+ 8. Coupling
+ 9. Transmission
+ 10. Axes and power shafts
- 11. Suspension bracket
   11.1. Specifications
   11.2. Bottom lever of a forward suspension bracket
   11.3. Replacement of the plug of the bottom lever
   11.4. Replacement of the plug (G) of the bottom lever
   11.5. Forward stabilizer of cross-section stability
   11.6. Rack of a back suspension bracket
   11.7. Replacement of the plug of the back longitudinal lever of a back suspension bracket
   11.8. Replacement of the plug of the back cross-section lever (And and In) a back suspension bracket
   11.9. Back stabilizer of cross-section stability
   11.10. Corners of installation of forward wheels
   11.11. Adjustment of a convergence of back wheels
   11.12. Wear of tires
   11.13. Antisliding chains
   11.14. Wheel palpation
   11.15. Tightening of nuts of fastening of a wheel
   11.16. Shift of wheels
   11.17. Check of withdrawal and course instability of the car
   11.18. Care of disks from an aluminum alloy
   11.19. Search and elimination of malfunctions
   11.20. Diagnostics of wear of tires
+ 12. Steering
+ 13. Brake system
+ 14. Body
+ 15. Central air
+ 16. Electric equipment
+ 17. Appendix
+ 18. Electroschemes
Heavy Metal & Reflected



11.9. Back stabilizer of cross-section stability

PERFORMANCE ORDER
1. Remove draft of the stabilizer of cross-section stability.
2. Check a torque which is necessary for putting for a provorachivaniye of a pin of the spherical hinge of draft of the stabilizer.

If there are cracks in a protective cover, replace it and add greasing in the hinge.

Several times shake here and there a pin of the spherical hinge of draft of the stabilizer.

Screw on a pin of the spherical hinge самоконтрящуюся a nut and measure a torque.

Torque: 1,7–3,2 N • m

If the torque exceeds admissible values, replace draft of the stabilizer.

If the torque is much lower than admissible value, the spherical hinge can be reused, if it is not got jammed and has no excessive люфта.

3. Establish draft of the stabilizer and fix a nut so that the bottom nut settled down at distance And from a draft end face.

Distance (A) from an end face draft of the stabilizer to a nut: 4–6 mm