Hyundai Accent

Repair and car operation

Hyundai Accent
+ 1. Maintenance instruction
+ 2. Engine
+ 3. Greasing system
+ 4. Cooling system
+ 5. Control, decrease in toxicity
- 6. Fuel system
   6.1. Specifications (SOHC and DOHC)
   6.2. Check of the fuel pump
   6.3. Check of the pressure created by the fuel pump
   6.4. Checks of system of injection of MFI
   6.5. Control lamp of malfunctions (MIL)
   6.6. Diagnostic codes of malfunctions of "OBD-II"
   6.7. Diagnostic codes of malfunctions, except «OBD-II»
   6.8. Replacement of the fuel filter
   6.9. Replacement of the limiter of overflow (the double-thread valve)
   6.10. Fuel level sensor replacement
   6.11. Control system of the MFI engine
   6.12. Fuel nozzles
   6.13. Throttle knot
   6.14. A power supply system with the carburetor
   6.15. Check of frequency of rotation of idling
   6.16. Adjustment of frequency of rotation of idling
   6.17. Frequency of rotation of idling and adjustment of a fuel mix
   6.18. Check and adjustment of the starting arrangement
   6.19. Check and adjustment of a free wheeling of a cable of an accelerator
   6.20. Fuel tank
   6.21. Catching canister паров fuels
   6.22. Replacement of the fuel filter
   6.23. Carburetor
   6.24. Cable and accelerator pedal
   6.25. Search and elimination of malfunctions of fuel system with the carburetor
+ 7. Ignition system
+ 8. Coupling
+ 9. Transmission
+ 10. Axes and power shafts
+ 11. Suspension bracket
+ 12. Steering
+ 13. Brake system
+ 14. Body
+ 15. Central air
+ 16. Electric equipment
+ 17. Appendix
+ 18. Electroschemes

6.12. Fuel nozzles

Elements of system of supply of fuel

1–inlet collector;
2–bolt, 15–20 N • m;
3–throttle knot;
4–bolt, 15–20 N • m;
5–laying of throttle knot;
6–fuel highway;
7–air chamber.


1. Before separation топливопроводов remove pressure in fuel system as, otherwise, the fuel being under pressure, will intensively follow from fuel system.


Close connection by a towel to exclude the razbryzgivany fuels, caused by residual pressure in топливопроводе.

2. Remove the fuel highway together with fuel nozzles.


At removal of the fuel highway do not drop fuel nozzles.


1. Disconnect the socket from a fuel nozzle and measure resistance between socket contacts.

Resistance: 15,9± 0,35 Ohm

2. If the size of resistance differs from demanded value, replace a fuel nozzle.


1. Establish on a nozzle new sealing rings.
2. Grease sealing rings of nozzles with fuel.
3. At installation of nozzles turn them round an axis in one and other parties.
4. Be convinced that nozzles are densely inserted into the fuel highway.