Hyundai Accent

Repair and car operation


Hyundai Accent
+ 1. Maintenance instruction
+ 2. Engine
+ 3. Greasing system
+ 4. Cooling system
+ 5. Control, decrease in toxicity
- 6. Fuel system
   6.1. Specifications (SOHC and DOHC)
   6.2. Check of the fuel pump
   6.3. Check of the pressure created by the fuel pump
   6.4. Checks of system of injection of MFI
   6.5. Control lamp of malfunctions (MIL)
   6.6. Diagnostic codes of malfunctions of "OBD-II"
   6.7. Diagnostic codes of malfunctions, except «OBD-II»
   6.8. Replacement of the fuel filter
   6.9. Replacement of the limiter of overflow (the double-thread valve)
   6.10. Fuel level sensor replacement
   6.11. Control system of the MFI engine
   6.12. Fuel nozzles
   6.13. Throttle knot
   6.14. A power supply system with the carburetor
   6.15. Check of frequency of rotation of idling
   6.16. Adjustment of frequency of rotation of idling
   6.17. Frequency of rotation of idling and adjustment of a fuel mix
   6.18. Check and adjustment of the starting arrangement
   6.19. Check and adjustment of a free wheeling of a cable of an accelerator
   6.20. Fuel tank
   6.21. Catching canister паров fuels
   6.22. Replacement of the fuel filter
   6.23. Carburetor
   6.24. Cable and accelerator pedal
   6.25. Search and elimination of malfunctions of fuel system with the carburetor
+ 7. Ignition system
+ 8. Coupling
+ 9. Transmission
+ 10. Axes and power shafts
+ 11. Suspension bracket
+ 12. Steering
+ 13. Brake system
+ 14. Body
+ 15. Central air
+ 16. Electric equipment
+ 17. Appendix
+ 18. Electroschemes





6.19. Check and adjustment of a free wheeling of a cable of an accelerator
PERFORMANCE ORDER
1. Start up the engine and leave it to work at frequency of rotation of a cranked shaft idling.
2. Check that the cable of an accelerator has no free wheeling.
3. If the cable of an accelerator has a free wheeling, adjust it as follows:

– weaken an adjusting nut so that the lever of a butterfly valve was free;
– eliminate sharp excesses of a cable of an accelerator;
– to move a cable cover to the butterfly valve lever, rotate an adjusting nut till the beginning of moving of the lever of a butterfly valve, then unscrew it on one turn back and законтрите an adjusting nut.