Hyundai Accent

Repair and car operation



Hyundai Accent
+ 1. Maintenance instruction
+ 2. Engine
+ 3. Greasing system
+ 4. Cooling system
+ 5. Control, decrease in toxicity
- 6. Fuel system
   6.1. Specifications (SOHC and DOHC)
   6.2. Check of the fuel pump
   6.3. Check of the pressure created by the fuel pump
   6.4. Checks of system of injection of MFI
   6.5. Control lamp of malfunctions (MIL)
   6.6. Diagnostic codes of malfunctions of "OBD-II"
   6.7. Diagnostic codes of malfunctions, except «OBD-II»
   6.8. Replacement of the fuel filter
   6.9. Replacement of the limiter of overflow (the double-thread valve)
   6.10. Fuel level sensor replacement
   6.11. Control system of the MFI engine
   6.12. Fuel nozzles
   6.13. Throttle knot
   6.14. A power supply system with the carburetor
   6.15. Check of frequency of rotation of idling
   6.16. Adjustment of frequency of rotation of idling
   6.17. Frequency of rotation of idling and adjustment of a fuel mix
   6.18. Check and adjustment of the starting arrangement
   6.19. Check and adjustment of a free wheeling of a cable of an accelerator
   6.20. Fuel tank
   6.21. Catching canister паров fuels
   6.22. Replacement of the fuel filter
   6.23. Carburetor
   6.24. Cable and accelerator pedal
   6.25. Search and elimination of malfunctions of fuel system with the carburetor
+ 7. Ignition system
+ 8. Coupling
+ 9. Transmission
+ 10. Axes and power shafts
+ 11. Suspension bracket
+ 12. Steering
+ 13. Brake system
+ 14. Body
+ 15. Central air
+ 16. Electric equipment
+ 17. Appendix
+ 18. Electroschemes






6.16. Adjustment of frequency of rotation of idling

Adjustment conditions

Headlights, the electric fan of a radiator and all electric consumers should be switched off, and the transmission should be established in neutral situation.

PERFORMANCE ORDER
1. The engine should be heated-up to temperature of cooling liquid 80-95°C.
2. No more than on 5 with increase frequency of rotation of a cranked shaft to 2000-3000min-1.
3. Then let's to the engine work idling within 2 minutes.
4. By a tachometer determine frequency of rotation of idling. If frequency of rotation differs from demanded, adjust it, rotating the adjusting screw of frequency of idling of No. SAS-1.

Do not rotate the SAS-2 screw which defines люфт between a butterfly valve and the lever, and it is precisely adjusted by production of the car. If this adjustment is broken, adjustment of provision of a butterfly valve and adjustment of the starting arrangement cannot be executed rather precisely.