Hyundai Accent

Repair and car operation

Hyundai Accent
+ 1. Maintenance instruction
- 2. Engine
   + 2.1. SOHC engines
   - 2.2. DOHC engines
      2.2.1. Specifications
      2.2.2. Compression check
      2.2.3. Gear belt
      2.2.4. Poliklinova belt
      2.2.5. Engine support
      2.2.6. Forward cover
      2.2.7. Air filter (ACL)
      2.2.8. Head of cylinders
      2.2.9. Camshafts
      2.2.10. Replacement of a saddle of the valve
      2.2.11. Replacement of the directing plug of the valve
      2.2.12. Valve
      2.2.13. Rods
      2.2.14. Cranked shaft
      2.2.15. Flywheel
      2.2.16. Piston
      2.2.17. Final collector
      2.2.18. Inlet collector and air chamber
      2.2.19. Block of cylinders
      2.2.20. Removal and engine and transmission installation
      2.2.21. System of production of the fulfilled gases
      2.2.22. Search and elimination of malfunctions
+ 3. Greasing system
+ 4. Cooling system
+ 5. Control, decrease in toxicity
+ 6. Fuel system
+ 7. Ignition system
+ 8. Coupling
+ 9. Transmission
+ 10. Axes and power shafts
+ 11. Suspension bracket
+ 12. Steering
+ 13. Brake system
+ 14. Body
+ 15. Central air
+ 16. Electric equipment
+ 17. Appendix
+ 18. Electroschemes

2.2.11. Replacement of the directing plug of the valve

The directing plug of the valve is established by means of a press. Using the adaptation for installation of the directing plug of the valve 09221-25000 or the suitable tool, replace directing plug as follows.

PERFORMANCE ORDER

	1. Using the adaptation for installation of the directing plug of the valve, выпрессуйте the valve plug from a head of cylinders in the direction to the block of cylinders.
2. Put to an opening of a head of cylinders the new directing plug of the valve of the increased repair size.
3. The adaptation for installation of the directing plug of the valve 09221-22000 press the plug in a head of cylinders. The adaptation provides a plug press fitting on strictly certain depth. Measure a vystupaniye of the top part of the directing plug of the valve from a head of cylinders. Pay attention that vystupany the directing plug of the valve variously for inlet (47,2 mm) and final (39,1 mm) valves.
	4. After a press fitting of directing plugs of valves insert new valves and check a gap.
5. Each time at replacement of directing plugs of valves check and, if necessary, replace saddles of valves.