| 1. Establish the universal hinge on a shaft of a gear wheel of steering transfer. |
Prevention
If the steering column is equipped with the mechanism of adjustment of a tilt angle, satisfy the following conditions.
Default of these conditions can lead to deformation of an arm of a tilt angle therefore the lever of a tilt angle and a lever clamp can be damaged.
|
|
2. Before installation check that on an arm there is an opening for a hairpin.
1) If it so, fix the tilt angle lever in neutral situation and establish a hairpin stopper in an opening, then separate the tilt angle lever. |
|
2) Otherwise, fix the tilt angle lever about neutral situation. |
|
3. Screw a bolt fixing to a steering shaft an U-shaped element of the universal hinge. Inhaling moment: 15–20 N • m
|
|
4. Temporarily screw two assembly bolts. |
| 5. Screw two assembly nuts. Inhaling moment: 13–18 N • m
|
| 6. Tighten the demanded moment these inhalings two assembly bolts. |
|
7. If the stopper of a hairpin is established, move a steering column to the bottom situation. |