Hyundai Accent

Repair and car operation

Hyundai Accent
- 1. Maintenance instruction
   1.1. General information about the car
   1.2. Keys
   1.3. Immobilizer (anticreeping system of blocking of start of the engine)
   1.4. Anticreeping system
   1.5. Locks of doors
   1.6. Children's safety lock of a back door
   1.7. Forward seats
   1.8. Window regulators
   1.9. System of the centralized management of locks of doors
   1.10. Precautionary measures when using seat belts
   1.11. Care of seat belts
   1.12. Fastenings of seat belts of forward seats regulated on height
   1.13. A three-dot seat belt of the driver with the inertial mechanism of blocking
   1.14. A seat belt with fastening in two points (the central seat belt of back sitting)
   1.15. Children's seats
   1.16. Inflatable safety cushions
   1.17. Dashboard and kontrolno measuring devices
   1.18. Index of level of fuel
   1.19. The index of temperature of cooling liquid
   1.20. Speedometer
   1.21. Odometer (counter of the passable way)
   1.22. Counter of daily run
   1.23. Tachometer
   1.24. The combined switch of light of headlights and turn indexes
   1.25. Switch of a cleaner and windscreen washer
   1.26. Cleaner and washer of back glass
   1.27. Proof-reader of light of headlights
   1.28. Alarm light system
   1.29. Heater of back glass
   1.30. Switch of forward fog lights
   1.31. Switch of tail antifog light
   1.32. Electronic clock
   1.33. Lighter
   1.34. Forward ashtray
   1.35. Back ashtray
   1.36. Coaster
   1.37. Sun-protection shtorka
   1.38. Hatch
   1.39. Lamp of illumination of salon
   1.40. Ware box
   1.41. External rear-view mirrors
   1.42. Heater of external rear-view mirrors
   1.43. Folding of external rear-view mirrors
   1.44. Internal rear-view mirror
   1.45. Parking brake
   1.46. Folding of backs of seats
   1.47. Back door / trunk lid
   1.48. Emergency opening of the lock of a trunk lid
   1.49. Remote opening of the lock of a back door / trunk lid
   1.50. Remote opening of a cover of a bulk mouth of a fuel tank
   1.51. Cowl opening
   1.52. Antisolar peak
   1.53. Adjustment of height of installation of a steering wheel
   1.54. Sound signal
   1.55. Heating and ventilation system
   1.56. The air purifier for the evaporator and the fan
   1.57. Stereosystem
   1.58. Aerial
   1.59. Car driving
   1.60. Ignition lock
   1.61. Start-up of the engine of cars with the carburetor engine
   1.62. Mechanical transmission
   1.63. Automatic transmission
   1.64. Anti-blocking system of brakes
   1.65. Economic driving
   1.66. Smooth passing of turns
   1.67. Movement in winter conditions
   1.68. Trailer or car towage
   1.69. The engine is not started
   1.70. If the engine is normally scrolled by a starter, but not started
   1.71. If the engine decayed during movement
   1.72. Engine start-up from the storage battery of other car
   1.73. If the engine overheated
   1.74. Car towage
   1.75. Emergency towage
   1.76. Prevention of corrosion and periodic leaving
   1.77. Identification number of the car (VIN)
   1.78. Technical characteristics of the car
+ 2. Engine
+ 3. Greasing system
+ 4. Cooling system
+ 5. Control, decrease in toxicity
+ 6. Fuel system
+ 7. Ignition system
+ 8. Coupling
+ 9. Transmission
+ 10. Axes and power shafts
+ 11. Suspension bracket
+ 12. Steering
+ 13. Brake system
+ 14. Body
+ 15. Central air
+ 16. Electric equipment
+ 17. Appendix
+ 18. Electroschemes

1.62. Mechanical transmission

Position of the lever of gear shifting is traditional for five transfers of a forward course as it is represented in drawing.

Positions of the lever of gear shifting

Prevention

At inclusion of transfer of a backing, after a full stop of the car, detain the gear shifting lever at least on 3 with in neutral situation. After that move the lever to the provision of transfer of a backing.
When switching lever from the provision of the 5th transfer to the provision of the 4th transfer, watch to including by mistake the second transfer. Such sharp gear shifting can cause excessive increase in frequency of rotation of a cranked shaft of the engine (the shooter of a tachometer in a red zone) and can lead to engine damage.

Coupling use

Before inclusion of transfer it is necessary to squeeze out completely a coupling pedal, and then slowly it to release. The repeated pressing a pedal of coupling is necessary for making only after its reset. Do not hold a foot on a coupling pedal during car movement. It can result in wear of a disk of coupling. Do not use coupling for car deduction on a bias. For this purpose it is necessary to use the parking brake. Do not allow a sharp and repeating otpuskaniye of a pedal of coupling.

Receptions of the correct driving

Do not slide under a bias on neutral transfer. It is very dangerous. Always hold transfer of the included.

Be not accustomed driving at which it is necessary to brake sharply, and do not hold the left foot on a brake pedal constantly during driving. It conducts to an overheat of brakes and loss of efficiency of their work. On long descents it is necessary to apply braking by the engine to prevention of an overheat of brakes (including low gears).

At low gear inclusion, slightly brake the car. It will help to prevent excessive increase in frequency of rotation of a cranked shaft of the engine that can lead to its damage.

At a strong lateral wind reduce speed of movement of the car. It will improve its controllability.

Before inclusion of transfer of a backing be convinced that the car is completely stopped. Otherwise you can damage a transmission. To transfer the lever to the provision of a backing, at first squeeze out a coupling pedal, transfer the lever to neutral situation, wait 3 with, and then transfer the lever to the provision of a backing.

Be especially careful at movement on the slippery road, during braking, acceleration and gear shifting. On the slippery road, sharp change of speed of the car can lead to loss of coupling of wheels of the car with the road and management loss over the car.

Prevention

At control loss over the car on high speeds the risk of a perevorachivaniye of the car considerably increases.
Control loss often occurs, when two or more wheels move down from a road track, and the driver tries to return the car back on the road.
In case your car moved down from a road track, avoid sharp turn of a steering wheel. Instead, reduce speed of the car before again driving on the road.

To take out a key from the ignition lock

PERFORMANCE ORDER

1. Turn the ignition key in the situation "ASS" ("The additional equipment").

2. At the same time press and turn the ignition key counter-clockwise from the situation "ASS" ("The additional equipment") in the situation "LOCK" ("Blocking").

3. The ignition key can be taken out from the lock only in the situation "LOCK" ("Blocking").

Recommended speeds for gear shifting

For economic driving it is recommended to switch transfers on the speeds specified below.

Transfer	Recommended speed
with the 1st on the 2nd or with the 2nd on 1st	20 km/h
with the 2nd on the 3rd or with the 3rd on the 2nd	40 km/h
with the 3rd on the 4th or with the 4th on the 3rd	55 km/h
with the 4th on 5th or with the 5th on the 4th	75 km/h