Hyundai Accent
+ 1. Maintenance instruction
+ 2. Engine
+ 3. Greasing system
+ 4. Cooling system
+ 5. Control, decrease in toxicity
+ 6. Fuel system
+ 7. Ignition system
+ 8. Coupling
+ 9. Transmission
+ 10. Axes and power shafts
+ 11. Suspension bracket
+ 12. Steering
- 13. Brake system
13.1. Specifications
13.2. Anti-blocking system of brakes (ABS)
13.3. Pumping of hydraulic system of a drive of brakes with scanner use
13.4. Check and adjustment of provision of a pedal of a brake
13.5. Check of the vacuum amplifier of brakes
13.6. Pumping of hydraulic system of a drive of brakes
13.7. Adjustment of a course of the parking brake
13.8. Vacuum amplifier of brakes
13.9. Brake tubes and hoses
13.10. Pressure regulator
13.11. Brake pedal
13.12. Replacement of forward brake shoes
13.13. Support of a forward brake
13.14. Main brake cylinder
13.15. Replacement of brake shoes on back drum-type brakes
13.16. Replacement of the working brake cylinder
13.17. Parking brake
13.18. Hydraulic HECU ABS block
13.19. Sensor of frequency of rotation of a wheel
13.20. Search and elimination of malfunctions
+ 14. Body
+ 15. Central air
+ 16. Electric equipment
+ 17. Appendix
+ 18. Electroschemes
|
Support of a forward brake
1–brake shoe;
2–dustproof cover;
3–piston;
4–sealing ring;
5–a support with the cylinder;
6–protective cover;
7–plug bolt, 22–32 N • m;
8–pumping union;
9–dustproof cap;
10-hollow bolt, 25–30 N • m;
11-brake hose; |
12-washer;
13-protective cover;
14-a directing finger, 35–45 N • m;
15-bolt of fastening of a support, 65–75 N • m;
16-fixing element;
17-plug;
18-protective cover;
19-laying;
20-spring;
21-laying. |
Removal
| PERFORMANCE ORDER |
| 1. Turn out lower bolt, lift a support up and fix it a wire. |
|
2. Remove brake shoes. |
Prevention
Do not press a brake pedal after removal of brake shoes.
|
|
Check
| PERFORMANCE ORDER |
1. Check brake shoes on lack of wear or pollution by oil and, if necessary, replace them.
Thickness of overlays of brake shoes:
The nominal: 90 mm
The minimum admissible: 2,0 mm |
Prevention
Surely replace all blocks on one axis of the car even if only one block is worn-out. If brake shoes are repeatedly established, before removal they are necessary for marking.
|
|
2. Check overlays of brake shoes on absence of damages. |
|
Installation
| PERFORMANCE ORDER |
| 1. Establish clips of brake shoes. |
|
2. Establish brake shoes on each clip of brake shoes. |
Prevention
Brake shoe with the sensor of wear establish from the piston.
|
|
3. The special tool 09581-11000 press the piston into the support cylinder. |
|
4. Establish new brake shoes. |
Prevention
Never put greasing on a brake disk and brake shoes.
|
|
|
5. Screw a bolt and tighten it the demanded moment. Inhaling moment: 22–32 N • m
|
|
|
|