Hyundai Accent

Repair and car operation


Hyundai Accent
+ 1. Maintenance instruction
+ 2. Engine
+ 3. Greasing system
+ 4. Cooling system
+ 5. Control, decrease in toxicity
+ 6. Fuel system
+ 7. Ignition system
+ 8. Coupling
+ 9. Transmission
+ 10. Axes and power shafts
+ 11. Suspension bracket
+ 12. Steering
- 13. Brake system
   13.1. Specifications
   13.2. Anti-blocking system of brakes (ABS)
   13.3. Pumping of hydraulic system of a drive of brakes with scanner use
   13.4. Check and adjustment of provision of a pedal of a brake
   13.5. Check of the vacuum amplifier of brakes
   13.6. Pumping of hydraulic system of a drive of brakes
   13.7. Adjustment of a course of the parking brake
   13.8. Vacuum amplifier of brakes
   13.9. Brake tubes and hoses
   13.10. Pressure regulator
   13.11. Brake pedal
   13.12. Replacement of forward brake shoes
   13.13. Support of a forward brake
   13.14. Main brake cylinder
   13.15. Replacement of brake shoes on back drum-type brakes
   13.16. Replacement of the working brake cylinder
   13.17. Parking brake
   13.18. Hydraulic HECU ABS block
   13.19. Sensor of frequency of rotation of a wheel
   13.20. Search and elimination of malfunctions
+ 14. Body
+ 15. Central air
+ 16. Electric equipment
+ 17. Appendix
+ 18. Electroschemes





13.8. Vacuum amplifier of brakes
1–vacuum hose;
2–clip;
3–a pin with a head and an opening under шплинт;
4–nut, 8–12 N • m; 		5–rasporny laying;
6–laying;
7–vacuum amplifier of brakes.

Removal
PERFORMANCE ORDER
1. Disconnect brake tubes from the main brake cylinder.
2. Remove the main brake cylinder.
Prevention

Brake liquid dissolves paint, plastic and isolation of wires therefore at casual hit of liquid on a paint and varnish covering of the car or its components, wash out them a large amount of water.
3. Disconnect a vacuum hose from the vacuum amplifier of brakes.
4. In salon of the car remove spring шплинт, and remove a pin with a head and an opening under шплинт.
5. Remove the switch of stoplights.
6. Unscrew four nuts of fastening of the vacuum amplifier of brakes.
7. Remove the vacuum amplifier of brakes.

Installation

PERFORMANCE ORDER
1. Establish the vacuum amplifier of brakes with new laying on a partition of a motor compartment and fix four nuts.

Inhaling moment: 8–12 N • m
2. Connect draft to a pedal of a brake and establish a pin with a head and an opening under шплинт and fix its new spring the shplinty.
3. Establish the main brake cylinder on the vacuum amplifier of brakes and fix nuts.
4. From a motor compartment attach a vacuum hose to the vacuum amplifier of brakes.
5. Connect brake tubes and tighten connecting nuts of fastening of tubes.
6. Fill a popolnitelny tank of brake system with brake liquid. Remove air from a hydraulic contour of brake system.
7. Check absence of leakages of brake liquid.
8. Check and, if necessary, adjust height of installation of a pedal and a free wheeling of a pedal of a brake.
9. After installation put greasing on points of contact of a pedal of a brake and draft.