Hyundai Accent

Repair and car operation


Hyundai Accent
+ 1. Maintenance instruction
+ 2. Engine
+ 3. Greasing system
+ 4. Cooling system
+ 5. Control, decrease in toxicity
+ 6. Fuel system
+ 7. Ignition system
+ 8. Coupling
+ 9. Transmission
+ 10. Axes and power shafts
+ 11. Suspension bracket
+ 12. Steering
- 13. Brake system
   13.1. Specifications
   13.2. Anti-blocking system of brakes (ABS)
   13.3. Pumping of hydraulic system of a drive of brakes with scanner use
   13.4. Check and adjustment of provision of a pedal of a brake
   13.5. Check of the vacuum amplifier of brakes
   13.6. Pumping of hydraulic system of a drive of brakes
   13.7. Adjustment of a course of the parking brake
   13.8. Vacuum amplifier of brakes
   13.9. Brake tubes and hoses
   13.10. Pressure regulator
   13.11. Brake pedal
   13.12. Replacement of forward brake shoes
   13.13. Support of a forward brake
   13.14. Main brake cylinder
   13.15. Replacement of brake shoes on back drum-type brakes
   13.16. Replacement of the working brake cylinder
   13.17. Parking brake
   13.18. Hydraulic HECU ABS block
   13.19. Sensor of frequency of rotation of a wheel
   13.20. Search and elimination of malfunctions
+ 14. Body
+ 15. Central air
+ 16. Electric equipment
+ 17. Appendix
+ 18. Electroschemes





13.17. Parking brake
1–lever of the parking brake;
2–adjusting nut; 		3–cable of the parking brake.

Removal
PERFORMANCE ORDER
1. Remove the back console.
2. Unscrew an adjusting nut and remove a cable of the parking brake.
3. Remove the switch of the parking brake.
4. Remove knot of the lever of the parking brake.
5. Remove a wheel.
6. Remove a brake drum.
7. Remove brake shoes.
8. Disconnect a cable of the parking brake from the lever on a brake shoe.
9. Remove a clip, fixing a cover of a cable of the parking brake to a brake board.
10. Remove a pillow of back sitting.
11. Weaken clips of fastening of a cable of the parking brake and remove it from the car.

Check
PERFORMANCE ORDER
1. Check operation of the switch of the parking brake.
2. Check a ratchet of the lever of the parking brake on lack of wear.
3. Check a cable of the parking brake on lack of wear or damages.

Installation

PERFORMANCE ORDER
1. Check marking existence on the left and right cables of the parking brake and establish them on the places.
2. Move the lever of the parking brake on a brake shoe completely back and establish springs.
3. Establish condensing rings in the direction shown in drawing.
4. Grease with the recommended greasing a ratchet and a doggie of a ratchet of the lever of the parking brake.

The recommended lubricant: SAE J310, NLGI No. 2
5. After installation of the jack adjust a course of the lever of the parking brake.