Hyundai Accent

Repair and car operation

Hyundai Accent
+ 1. Maintenance instruction
+ 2. Engine
+ 3. Greasing system
+ 4. Cooling system
+ 5. Control, decrease in toxicity
+ 6. Fuel system
+ 7. Ignition system
+ 8. Coupling
+ 9. Transmission
+ 10. Axes and power shafts
+ 11. Suspension bracket
+ 12. Steering
- 13. Brake system
   13.1. Specifications
   13.2. Anti-blocking system of brakes (ABS)
   13.3. Pumping of hydraulic system of a drive of brakes with scanner use
   13.4. Check and adjustment of provision of a pedal of a brake
   13.5. Check of the vacuum amplifier of brakes
   13.6. Pumping of hydraulic system of a drive of brakes
   13.7. Adjustment of a course of the parking brake
   13.8. Vacuum amplifier of brakes
   13.9. Brake tubes and hoses
   13.10. Pressure regulator
   13.11. Brake pedal
   13.12. Replacement of forward brake shoes
   13.13. Support of a forward brake
   13.14. Main brake cylinder
   13.15. Replacement of brake shoes on back drum-type brakes
   13.16. Replacement of the working brake cylinder
   13.17. Parking brake
   13.18. Hydraulic HECU ABS block
   13.19. Sensor of frequency of rotation of a wheel
   13.20. Search and elimination of malfunctions
+ 14. Body
+ 15. Central air
+ 16. Electric equipment
+ 17. Appendix
+ 18. Electroschemes

13.16. Replacement of the working brake cylinder

1. Remove brake shoes.
2. Disconnect a brake tube.
3. Turn out bolts and remove the working brake cylinder.
4. Remove dustproof covers from the working brake cylinder.
5. Remove the piston.
6. Get a returnable spring.
7. Before assembly of the working brake cylinder check a condition of the following details:

– the cylinder and the piston on lack of wear, damages and a rust;
– the case of the working brake cylinder on absence of damages and cracks;
– a contact surface of the piston and brake shoes on lack of wear.
8. Assembly is carried out in sequence, return dismantling.


Before assembly clear the working brake cylinder isopropyl alcohol.
Before assembly grease with brake liquid the piston and the cylinder.
At assembly it is necessary to use new cuffs and dustproof covers.
Be careful not to lose a steel ball of the drainage valve.