купить диплом для иностранцев по ЛУЧШЕЙ ЦЕНЕ.

Hyundai Accent

Repair and car operation



Hyundai Accent
+ 1. Maintenance instruction
+ 2. Engine
+ 3. Greasing system
+ 4. Cooling system
+ 5. Control, decrease in toxicity
+ 6. Fuel system
+ 7. Ignition system
+ 8. Coupling
+ 9. Transmission
+ 10. Axes and power shafts
+ 11. Suspension bracket
+ 12. Steering
+ 13. Brake system
+ 14. Body
+ 15. Central air
- 16. Electric equipment
   16.1. Specifications
   16.2. Electric chains
   16.3. Charging system
   16.4. Check of an electric chain of a charging
   16.5. Power failure check on a wire connecting the storage battery to the generator
   16.6. Check of the current developed by the generator
   16.7. Check of developed tension
   16.8. Generator
   16.9. Storage battery
   16.10. Check of specific weight of electrolit
   16.11. Charging of the storage battery
   16.12. Survey of the storage battery
   16.13. Start system
   16.14. Starter
   16.15. Check and replacement of elements of a stator
   16.16. Switch of blocking of ignition
   16.17. Check of the relay of a starter
   16.18. Check of the switch of blocking of ignition
   16.19. Radio receiver
   16.20. Loudspeakers
   16.21. Aerial
   16.22. Multipurpose switch
   16.23. Sound signal
   16.24. Safety locks
   16.25. Combination of devices
   16.26. Engine of a screen wiper of a windscreen
   16.27. Replacement of a headlight and forward index of turn
   16.28. Adjustment of light of headlights
+ 17. Appendix
+ 18. Electroschemes






16.13. Start system

The system of start turns on the storage battery, a starter, the traction relay, the lock of ignition blocking the switch (only on cars with an automatic transmission) and wires.

At starter inclusion through a winding of the traction relay of a starter the current from the storage battery starts to proceed, the anchor of the relay is involved and contacts of the relay become isolated. At the same time the relay anchor via the lever moves the obgonny coupling with a gear wheel. The nave of the obgonny coupling turns on screw shlitsa of a shaft of a starter together with a gear wheel that facilitates input it in gearing with a gear wreath of a flywheel. Through the closed contacts of the traction relay there is a current feeding windings of a stator and an anchor, and the anchor of a starter starts to rotate together with a nave and the obgonny coupling.

After the engine starts to work, frequency of rotation of a gear wheel exceeds frequency of rotation of an anchor of a starter, the obgonny coupling is freely turned and the torque is not transferred from a flywheel to a starter shaft. After an ignition key otpuskaniye the power-supply circuit of a winding of the traction relay is disconnected, the anchor of the traction relay is wrung out by a spring in a starting position, contacts of the relay are disconnected and the gear wheel of a drive leaves gearing with a gear wreath of a flywheel.