|
|
Hyundai AccentRepair and car operation |
|
|
Hyundai Accent + 1. Maintenance instruction + 2. Engine + 3. Greasing system + 4. Cooling system + 5. Control, decrease in toxicity + 6. Fuel system + 7. Ignition system + 8. Coupling + 9. Transmission + 10. Axes and power shafts + 11. Suspension bracket + 12. Steering + 13. Brake system + 14. Body + 15. Central air - 16. Electric equipment 16.1. Specifications 16.2. Electric chains 16.3. Charging system 16.4. Check of an electric chain of a charging 16.5. Power failure check on a wire connecting the storage battery to the generator 16.6. Check of the current developed by the generator 16.7. Check of developed tension 16.8. Generator 16.9. Storage battery 16.10. Check of specific weight of electrolit 16.11. Charging of the storage battery 16.12. Survey of the storage battery 16.13. Start system 16.14. Starter 16.15. Check and replacement of elements of a stator 16.16. Switch of blocking of ignition 16.17. Check of the relay of a starter 16.18. Check of the switch of blocking of ignition 16.19. Radio receiver 16.20. Loudspeakers 16.21. Aerial 16.22. Multipurpose switch 16.23. Sound signal 16.24. Safety locks 16.25. Combination of devices 16.26. Engine of a screen wiper of a windscreen 16.27. Replacement of a headlight and forward index of turn 16.28. Adjustment of light of headlights + 17. Appendix + 18. Electroschemes |
16.24. Safety locksSafety locks serve to break off a chain, when the current will reach a certain value to protect elements and wires which can be damaged by too strong current. The sharp increase in a current is usually caused by malfunction in a chain, more often short circuit.Designations of the chains protected by safety locks, are specified on a cover of the block of safety locks. Before removal of a safety lock switch off the corresponding chain (or ignition), then get a safety lock from contacts. In a safety lock the wire should be visible; if the safety lock fused, the wire will be torn or melted. Always use safety locks of the demanded capacity. Never use a safety lock of other capacity and do not replace it with something another. Do not replace a safety lock more than once, without having eliminated a malfunction source. The current protected by a safety lock, is specified from above on a safety lock: pay attention that safety locks have various colors for simplification of identification. If the safety lock fuses right after replacement, do not replace it again, yet do not establish, and do not eliminate a cause of defect. In most cases a cause of defect is the short circuit caused by a low insulation. If the safety lock protects some chains, try to find a chain because of which fuses a safety lock, including each of chains in turn (if it is possible). Always have in the car a set of spare safety locks of various capacity. They should be fixed at the basis of the block of safety locks. The electric chains protected by safety locks, located in a motor compartment
|
|