Hyundai Accent

Repair and car operation

Hyundai Accent
+ 1. Maintenance instruction
+ 2. Engine
+ 3. Greasing system
+ 4. Cooling system
+ 5. Control, decrease in toxicity
+ 6. Fuel system
+ 7. Ignition system
+ 8. Coupling
+ 9. Transmission
+ 10. Axes and power shafts
+ 11. Suspension bracket
+ 12. Steering
+ 13. Brake system
+ 14. Body
+ 15. Central air
- 16. Electric equipment
   16.1. Specifications
   16.2. Electric chains
   16.3. Charging system
   16.4. Check of an electric chain of a charging
   16.5. Power failure check on a wire connecting the storage battery to the generator
   16.6. Check of the current developed by the generator
   16.7. Check of developed tension
   16.8. Generator
   16.9. Storage battery
   16.10. Check of specific weight of electrolit
   16.11. Charging of the storage battery
   16.12. Survey of the storage battery
   16.13. Start system
   16.14. Starter
   16.15. Check and replacement of elements of a stator
   16.16. Switch of blocking of ignition
   16.17. Check of the relay of a starter
   16.18. Check of the switch of blocking of ignition
   16.19. Radio receiver
   16.20. Loudspeakers
   16.21. Aerial
   16.22. Multipurpose switch
   16.23. Sound signal
   16.24. Safety locks
   16.25. Combination of devices
   16.26. Engine of a screen wiper of a windscreen
   16.27. Replacement of a headlight and forward index of turn
   16.28. Adjustment of light of headlights
+ 17. Appendix
+ 18. Electroschemes

16.4. Check of an electric chain of a charging

PERFORMANCE ORDER

1. Include ignition.
2. After ignition inclusion at the working engine the control lamp of a charging of the storage battery should burn.
	3. Disconnect the socket from the resistor of preliminary excitement of the generator. Connect an ohmmeter to contacts 1 and 3 sockets from components. Positive щуп (+) an ohmmeter connect to contact 3, and negative щуп (–) – to contact 1.
Prevention If it is wrong to connect an ohmmeter, it will not show value of resistance

Result

PERFORMANCE ORDER

1. If there is a conductivity shown by an ohmmeter, means, an electric chain as it should be. If conductivity is absent, means, the electric chain is faulty.

2. If conductivity is absent only on a step 3, check and restore an electric chain of a control lamp. If conductivity is absent only on a step 2, check the resistor of preliminary excitement of the generator.

Prevention

If conductivity is absent only on one of steps 2 and 3, means, the system works normally, however, for more reliable work of system it is necessary to inspect an electric chain.