Hyundai Accent

Repair and car operation



Hyundai Accent
+ 1. Maintenance instruction
+ 2. Engine
+ 3. Greasing system
+ 4. Cooling system
+ 5. Control, decrease in toxicity
+ 6. Fuel system
+ 7. Ignition system
+ 8. Coupling
+ 9. Transmission
+ 10. Axes and power shafts
+ 11. Suspension bracket
+ 12. Steering
+ 13. Brake system
+ 14. Body
+ 15. Central air
- 16. Electric equipment
   16.1. Specifications
   16.2. Electric chains
   16.3. Charging system
   16.4. Check of an electric chain of a charging
   16.5. Power failure check on a wire connecting the storage battery to the generator
   16.6. Check of the current developed by the generator
   16.7. Check of developed tension
   16.8. Generator
   16.9. Storage battery
   16.10. Check of specific weight of electrolit
   16.11. Charging of the storage battery
   16.12. Survey of the storage battery
   16.13. Start system
   16.14. Starter
   16.15. Check and replacement of elements of a stator
   16.16. Switch of blocking of ignition
   16.17. Check of the relay of a starter
   16.18. Check of the switch of blocking of ignition
   16.19. Radio receiver
   16.20. Loudspeakers
   16.21. Aerial
   16.22. Multipurpose switch
   16.23. Sound signal
   16.24. Safety locks
   16.25. Combination of devices
   16.26. Engine of a screen wiper of a windscreen
   16.27. Replacement of a headlight and forward index of turn
   16.28. Adjustment of light of headlights
+ 17. Appendix
+ 18. Electroschemes
Heavy Metal & Reflected


16.28. Adjustment of light of headlights

Light of headlights should be adjusted with use of the special equipment and according to instructions of the manufacturer of the equipment. Serially rotate adjusting wheels to adjust a stream of light of headlights. If the special equipment is inaccessible, execute adjustment as follows.



PERFORMANCE ORDER
1. Finish pressure in tires to the demanded. In the car there should be only a driver, the tool and a spare wheel.
2. Establish the car on an equal horizontal surface in front of the screen or a wall.
3. On the screen carry out the vertical lines passing through the center of each headlight, and the horizontal line being on the center of headlights.
4. Include headlights and, rotating adjusting wheels, adjust their situation so that the most light spot settled down according to the shaded area in drawing.