Hyundai Accent

Repair and car operation


Hyundai Accent
+ 1. Maintenance instruction
+ 2. Engine
+ 3. Greasing system
+ 4. Cooling system
+ 5. Control, decrease in toxicity
+ 6. Fuel system
+ 7. Ignition system
+ 8. Coupling
+ 9. Transmission
+ 10. Axes and power shafts
+ 11. Suspension bracket
+ 12. Steering
+ 13. Brake system
+ 14. Body
- 15. Central air
   15.1. Specifications
   15.2. Instruction on coolant application
   15.3. Remarks at replacement of elements of central air of air
   15.4. Connection of elements of central air of air
   15.5. Check of elements of central air established on the car
   15.6. Installation of manometers for pressure measurement
   15.7. Pumping of atmospheric air from central air
   15.8. Charging of central air of air
   15.9. Check of level of a coolant
   15.10. Verification of operational characteristics
   15.11. Oil for greasing of the compressor of the conditioner
   15.12. Relay check
   15.13. Conditioner compressor
   15.14. Plug of coupling and pulley of the compressor of the conditioner
   15.15. Coil of initiation of coupling
   15.16. Compressor check on the car
   15.17. Sensor of threefold (double) pressure
   15.18. Fan and condenser
   15.19. Evaporator
   15.20. Check of the thermostatic sensor (termistor)
   15.21. Air filter of the evaporator
   15.22. Heating and ventilation block
   15.23. Heater block
   15.24. Fan
   15.25. Search and elimination of malfunctions
+ 16. Electric equipment
+ 17. Appendix
+ 18. Electroschemes





15.12. Relay check
PERFORMANCE ORDER
1. Disconnect a wire from the negative plug of the storage battery.
2. Uncover the block of the relay located in a motor compartment.
3. Remove the relay from the relay block.
4. Check conductivity between relay contacts.

Check of the relay of central air of air


If conductivity differs from demanded, replace the relay.

Check of the relay of the fan of the condenser

If conductivity differs from demanded, replace the relay.

Relay of the fan of a heater

PERFORMANCE ORDER
1. Disconnect a wire from the negative plug of the storage battery.
2. Disconnect the socket from the switch of the fan of a heater.
3. Remove the relay and check conductivity between relay contacts.
If conductivity differs from demanded, replace the relay.