Hyundai Accent

Repair and car operation



Hyundai Accent
+ 1. Maintenance instruction
+ 2. Engine
+ 3. Greasing system
+ 4. Cooling system
+ 5. Control, decrease in toxicity
+ 6. Fuel system
+ 7. Ignition system
+ 8. Coupling
+ 9. Transmission
+ 10. Axes and power shafts
+ 11. Suspension bracket
+ 12. Steering
+ 13. Brake system
+ 14. Body
- 15. Central air
   15.1. Specifications
   15.2. Instruction on coolant application
   15.3. Remarks at replacement of elements of central air of air
   15.4. Connection of elements of central air of air
   15.5. Check of elements of central air established on the car
   15.6. Installation of manometers for pressure measurement
   15.7. Pumping of atmospheric air from central air
   15.8. Charging of central air of air
   15.9. Check of level of a coolant
   15.10. Verification of operational characteristics
   15.11. Oil for greasing of the compressor of the conditioner
   15.12. Relay check
   15.13. Conditioner compressor
   15.14. Plug of coupling and pulley of the compressor of the conditioner
   15.15. Coil of initiation of coupling
   15.16. Compressor check on the car
   15.17. Sensor of threefold (double) pressure
   15.18. Fan and condenser
   15.19. Evaporator
   15.20. Check of the thermostatic sensor (termistor)
   15.21. Air filter of the evaporator
   15.22. Heating and ventilation block
   15.23. Heater block
   15.24. Fan
   15.25. Search and elimination of malfunctions
+ 16. Electric equipment
+ 17. Appendix
+ 18. Electroschemes






15.8. Charging of central air of air


Prevention

The charging of central air of air through the party with low pressure a coolant is given in a gaseous state. When the cooling container is placed on the right side, the coolant will be included into system as steam.


PERFORMANCE ORDER
1. Connect station of service of central air of air, as is shown in drawing.
2. Open the valve of low pressure and adjust it so that the manometer of low pressure showed pressure no more than 412 kPas.
3. Place the container with a coolant in the water which has been heated up to temperature no more 40°C to support a vapor pressure in the container a little above, than a vapor pressure in system.
4. Start the engine in a mode of the accelerated idling and turn on the conditioner.

Prevention

Be convinced that support a container rack to interfere with hit of a liquid coolant through the party with low pressure as damage of the compressor of the conditioner is thus possible.


5. Charge system precisely established quantity of a coolant and close the delivery valve.

Quantity of a coolant: 575-625 g