Hyundai Accent

Repair and car operation

Hyundai Accent
+ 1. Maintenance instruction
+ 2. Engine
+ 3. Greasing system
+ 4. Cooling system
+ 5. Control, decrease in toxicity
+ 6. Fuel system
+ 7. Ignition system
+ 8. Coupling
+ 9. Transmission
+ 10. Axes and power shafts
+ 11. Suspension bracket
+ 12. Steering
+ 13. Brake system
+ 14. Body
- 15. Central air
   15.1. Specifications
   15.2. Instruction on coolant application
   15.3. Remarks at replacement of elements of central air of air
   15.4. Connection of elements of central air of air
   15.5. Check of elements of central air established on the car
   15.6. Installation of manometers for pressure measurement
   15.7. Pumping of atmospheric air from central air
   15.8. Charging of central air of air
   15.9. Check of level of a coolant
   15.10. Verification of operational characteristics
   15.11. Oil for greasing of the compressor of the conditioner
   15.12. Relay check
   15.13. Conditioner compressor
   15.14. Plug of coupling and pulley of the compressor of the conditioner
   15.15. Coil of initiation of coupling
   15.16. Compressor check on the car
   15.17. Sensor of threefold (double) pressure
   15.18. Fan and condenser
   15.19. Evaporator
   15.20. Check of the thermostatic sensor (termistor)
   15.21. Air filter of the evaporator
   15.22. Heating and ventilation block
   15.23. Heater block
   15.24. Fan
   15.25. Search and elimination of malfunctions
+ 16. Electric equipment
+ 17. Appendix
+ 18. Electroschemes

15.15. Coil of initiation of coupling

Removal

PERFORMANCE ORDER

1. Remove the plug of coupling and a pulley of the compressor of the conditioner.
2. Establish the safety tool on an open opening of a shaft of the compressor.
	3. Establish a stripper on the compressor how it is shown in drawing. Establish a tip of the press screw in dredging of the safety tool of a shaft of the compressor and tighten the stripper screw.
4. Tightening a wrench the stripper screw, remove the coil from the forward party of the compressor.
Prevention Do not use pneumatic tools.

Installation

PERFORMANCE ORDER

1. Clear the coil of initiation of coupling.

2. Establish the compressor vertically, shaft up, and establish the coil of initiation of coupling on the forward party of the compressor. Be convinced that the electric socket of the coil is located correctly.

3. Establish the safety tool on an open opening of a shaft of the compressor.

4. Establish the tool of a press fitting of the coil on internal radius of the coil of excitement.

5. Tighten a wrench the tool screw before coil installation into place.

6. Establish the plug of coupling and a pulley of the compressor of the conditioner.