Hyundai Accent

Repair and car operation

Hyundai Accent
+ 1. Maintenance instruction
+ 2. Engine
+ 3. Greasing system
+ 4. Cooling system
+ 5. Control, decrease in toxicity
+ 6. Fuel system
+ 7. Ignition system
+ 8. Coupling
+ 9. Transmission
+ 10. Axes and power shafts
+ 11. Suspension bracket
+ 12. Steering
+ 13. Brake system
+ 14. Body
- 15. Central air
   15.1. Specifications
   15.2. Instruction on coolant application
   15.3. Remarks at replacement of elements of central air of air
   15.4. Connection of elements of central air of air
   15.5. Check of elements of central air established on the car
   15.6. Installation of manometers for pressure measurement
   15.7. Pumping of atmospheric air from central air
   15.8. Charging of central air of air
   15.9. Check of level of a coolant
   15.10. Verification of operational characteristics
   15.11. Oil for greasing of the compressor of the conditioner
   15.12. Relay check
   15.13. Conditioner compressor
   15.14. Plug of coupling and pulley of the compressor of the conditioner
   15.15. Coil of initiation of coupling
   15.16. Compressor check on the car
   15.17. Sensor of threefold (double) pressure
   15.18. Fan and condenser
   15.19. Evaporator
   15.20. Check of the thermostatic sensor (termistor)
   15.21. Air filter of the evaporator
   15.22. Heating and ventilation block
   15.23. Heater block
   15.24. Fan
   15.25. Search and elimination of malfunctions
+ 16. Electric equipment
+ 17. Appendix
+ 18. Electroschemes

15.14. Plug of coupling and pulley of the compressor of the conditioner

Coupling and pulley of the compressor of the conditioner

1–rasporny plug;
2–pulley and bearing;
3–excitement coil;
4–socket of the electromagnetic coupling;
5–sealing ring;
6–knot of pipelines;
7–bolt, 16,3–26,6 N • m;
9–conditioner compressor;
10-shaft consolidation;
11-sealing ring;
13-lock ring;
14-disk and plug;
15-bolt, 10,2–15,3 N • m.


1. Turn out a bolt of fastening of the plug of the coupling, thus a special key 09977–34000 hold the plug from a provorachivaniye.
2. Remove the coupling and laying plug from a compressor shaft. If the plug does not act in film, screw a bolt on М8 in an opening of a shaft of the plug and for a bolt remove the plug.
3. Remove a lock ring.
4. Remove a pulley and the bearing from a compressor shaft.


1. Clear a working surface of the bearing of a pulley of the compressor and remove dirt and corrosion traces.
2. Establish a pulley and the bearing on a compressor shaft.
3. Establish a lock ring.
4. Arrange one laying of the rasporny plug of nominal thickness in a flute of the plug and establish the plug on a compressor shaft.
5. Establish the new plug and fix it a bolt, having tightened it the demanded moment.

Inhaling moment: 10,2–15,3 N • m


Do not use pneumatic tools.

6. Shchup check a gap of coupling of the compressor of the conditioner between the plug of coupling and a pulley. Check a gap in three points on pulley perimeter.

Gap: 0,35–0,75 mm

7. If the gap differs from demanded, adjust it, having established laying of the corresponding thickness.