Hyundai Accent

Repair and car operation



Hyundai Accent
+ 1. Maintenance instruction
+ 2. Engine
+ 3. Greasing system
+ 4. Cooling system
+ 5. Control, decrease in toxicity
+ 6. Fuel system
+ 7. Ignition system
+ 8. Coupling
- 9. Transmission
   + 9.1. Mechanical transmission
   - 9.2. Automatic transmission
      9.2.1. Specifications
      9.2.2. Control lamp of malfunctions (MIL)
      9.2.3. Diagnostic codes of malfunctions
      9.2.4. Reading of codes of malfunctions
      9.2.5. Check of pressure of transmission liquid
      9.2.6. Testing of collaboration of an automatic transmission and the engine on the motionless car (stall test)
      9.2.7. Check of level of liquid in an automatic transmission
      9.2.8. Check of operation of the lever of the selector
      9.2.9. Adjustment of the switch of indication of position of the lever of the selector
      9.2.10. Adjustment of the servo-driver of compulsory inclusion of a low gear
      9.2.11. Pressure adjustment in the highway
      9.2.12. Replacement of an oil sealing ring of a power shaft
      9.2.13. Replacement of a cable of a drive of a speedometer
      9.2.14. Removal and transmission installation
      9.2.15. Transmission repair
      9.2.16. Selector lever
      9.2.17. Adjustment of a cable of management
      9.2.18. Repair of the lever of the selector
+ 10. Axes and power shafts
+ 11. Suspension bracket
+ 12. Steering
+ 13. Brake system
+ 14. Body
+ 15. Central air
+ 16. Electric equipment
+ 17. Appendix
+ 18. Electroschemes






9.2.10. Adjustment of the servo-driver of compulsory inclusion of a low gear

PERFORMANCE ORDER
1. Clear all dirt of the screw of adjustment of the servo-driver of compulsory inclusion of a low gear.
2. Weaken a lock-nut.
3. Two times weaken and tighten the screw of adjustment the moment of an inhaling of 5 N • m.
4. After a tightening of the screw of adjustment the moment of an inhaling of 5 N • m weaken it on 3–31/3 turns.
5. Tighten a lock-nut the demanded moment.

Inhaling moment: 15–22 N • m


Prevention

Before adjustment put DC780на hermetic a carving of the screw of adjustment of the servo-driver of compulsory inclusion of a low gear.