The device, service, Hyundai Accent repair - 9.2.13. Replacement of a cable of a drive of a speedometer//effexor-xr.ru

Hyundai Accent

Repair and car operation



Hyundai Accent
+ 1. Maintenance instruction
+ 2. Engine
+ 3. Greasing system
+ 4. Cooling system
+ 5. Control, decrease in toxicity
+ 6. Fuel system
+ 7. Ignition system
+ 8. Coupling
- 9. Transmission
   + 9.1. Mechanical transmission
   - 9.2. Automatic transmission
      9.2.1. Specifications
      9.2.2. Control lamp of malfunctions (MIL)
      9.2.3. Diagnostic codes of malfunctions
      9.2.4. Reading of codes of malfunctions
      9.2.5. Check of pressure of transmission liquid
      9.2.6. Testing of collaboration of an automatic transmission and the engine on the motionless car (stall test)
      9.2.7. Check of level of liquid in an automatic transmission
      9.2.8. Check of operation of the lever of the selector
      9.2.9. Adjustment of the switch of indication of position of the lever of the selector
      9.2.10. Adjustment of the servo-driver of compulsory inclusion of a low gear
      9.2.11. Pressure adjustment in the highway
      9.2.12. Replacement of an oil sealing ring of a power shaft
      9.2.13. Replacement of a cable of a drive of a speedometer
      9.2.14. Removal and transmission installation
      9.2.15. Transmission repair
      9.2.16. Selector lever
      9.2.17. Adjustment of a cable of management
      9.2.18. Repair of the lever of the selector
+ 10. Axes and power shafts
+ 11. Suspension bracket
+ 12. Steering
+ 13. Brake system
+ 14. Body
+ 15. Central air
+ 16. Electric equipment
+ 17. Appendix
+ 18. Electroschemes
Heavy Metal & Reflected



9.2.13. Replacement of a cable of a drive of a speedometer

PERFORMANCE ORDER
1. Insert correctly the adapter from a reverse side into a combination of devices and fix a new cable of a speedometer.
2. Establish a sealing ring so that the attached part of a cable settled down horizontally, in relation to the car.

Prevention

It is necessary to establish a cable so that the radius of a bend of a cable was not less than 150 mm.


3. Insert a speedometer cable into a transmission and reliably fix it a connecting nut.

Prevention

If the cable is incorrectly located and unreliably connected, indications of a speedometer can be incorrect and at rotation of a cable there can be an extraneous noise.