Hyundai Accent

Repair and car operation



Hyundai Accent
+ 1. Maintenance instruction
+ 2. Engine
+ 3. Greasing system
+ 4. Cooling system
+ 5. Control, decrease in toxicity
+ 6. Fuel system
+ 7. Ignition system
+ 8. Coupling
- 9. Transmission
   + 9.1. Mechanical transmission
   - 9.2. Automatic transmission
      9.2.1. Specifications
      9.2.2. Control lamp of malfunctions (MIL)
      9.2.3. Diagnostic codes of malfunctions
      9.2.4. Reading of codes of malfunctions
      9.2.5. Check of pressure of transmission liquid
      9.2.6. Testing of collaboration of an automatic transmission and the engine on the motionless car (stall test)
      9.2.7. Check of level of liquid in an automatic transmission
      9.2.8. Check of operation of the lever of the selector
      9.2.9. Adjustment of the switch of indication of position of the lever of the selector
      9.2.10. Adjustment of the servo-driver of compulsory inclusion of a low gear
      9.2.11. Pressure adjustment in the highway
      9.2.12. Replacement of an oil sealing ring of a power shaft
      9.2.13. Replacement of a cable of a drive of a speedometer
      9.2.14. Removal and transmission installation
      9.2.15. Transmission repair
      9.2.16. Selector lever
      9.2.17. Adjustment of a cable of management
      9.2.18. Repair of the lever of the selector
+ 10. Axes and power shafts
+ 11. Suspension bracket
+ 12. Steering
+ 13. Brake system
+ 14. Body
+ 15. Central air
+ 16. Electric equipment
+ 17. Appendix
+ 18. Electroschemes






9.2.9. Adjustment of the switch of indication of position of the lever of the selector

PERFORMANCE ORDER
1. Move the selector lever to a position N.
2. Weaken a control lever lock-nut in a cable and lever junction.
3. Move a control lever to situation N.
4. Turn the case of the switch of indication of position of the lever of the selector on distance to 12 mm and combine the wide end of a control lever with a switch ledge.
5. Tighten bolts of fastening of the switch the moment of an inhaling of 10-12 N • m.

Prevention

At turn of the case of the switch be careful not to damage a sealing ring.


6. Check that the lever of the selector is in a position N.
7. Adjust the provision of a nut so that there was no sagging of a cable and the lever of the selector moved smoothly.
8. Make a control trip and be convinced that the transmission is established in the situation corresponding to each position of the lever of the selector.