Hyundai Accent

Repair and car operation

Hyundai Accent
+ 1. Maintenance instruction
+ 2. Engine
+ 3. Greasing system
+ 4. Cooling system
+ 5. Control, decrease in toxicity
+ 6. Fuel system
+ 7. Ignition system
+ 8. Coupling
- 9. Transmission
   + 9.1. Mechanical transmission
   - 9.2. Automatic transmission
      9.2.1. Specifications
      9.2.2. Control lamp of malfunctions (MIL)
      9.2.3. Diagnostic codes of malfunctions
      9.2.4. Reading of codes of malfunctions
      9.2.5. Check of pressure of transmission liquid
      9.2.6. Testing of collaboration of an automatic transmission and the engine on the motionless car (stall test)
      9.2.7. Check of level of liquid in an automatic transmission
      9.2.8. Check of operation of the lever of the selector
      9.2.9. Adjustment of the switch of indication of position of the lever of the selector
      9.2.10. Adjustment of the servo-driver of compulsory inclusion of a low gear
      9.2.11. Pressure adjustment in the highway
      9.2.12. Replacement of an oil sealing ring of a power shaft
      9.2.13. Replacement of a cable of a drive of a speedometer
      9.2.14. Removal and transmission installation
      9.2.15. Transmission repair
      9.2.16. Selector lever
      9.2.17. Adjustment of a cable of management
      9.2.18. Repair of the lever of the selector
+ 10. Axes and power shafts
+ 11. Suspension bracket
+ 12. Steering
+ 13. Brake system
+ 14. Body
+ 15. Central air
+ 16. Electric equipment
+ 17. Appendix
+ 18. Electroschemes

9.2.14. Removal and transmission installation

Removal

PERFORMANCE ORDER

1. Disconnect, first of all, a wire from the negative plug of the storage battery, then - from positive. Turn out a drain stopper and merge in suitable capacity transmission oil from a transmission.
	2. Remove the case of the air filter.
3. Weaken collars and disconnect hoses of giving and return of transmission liquid to a radiator.
	Prevention For a hit exception in a transmission of dirt and a dust close openings suitable jams.
4. Remove a cable of management of a transmission.
	5. Remove a cable of a drive of a speedometer.
	6. Disconnect electric sockets from the generator of impulses, the switch of ranges of a transmission, the switch of the servo-driver of compulsory inclusion of a low gear, the electromagnetic valve and the sensor of temperature of transmission liquid.
	7. Turn out bolts of fastening of the top part of a transmission to the engine.
8. The special adaptation support the engine so that the weight of the engine was perceived by the adaptation.
9. Disconnect the stabilizer of cross-section stability, connecting draft, the spherical hinge of the bottom lever and power shafts.
10. Turn out connecting sharnirny bolts of a transmission and assembly bolts of fastening of returnable pipes.
	11. Turn out bolts and remove the bottom frame.
	12. Remove a starter.
13. Turn out bolts of fastening of a transmission.
14. Take away a transmission from the engine.
15. Remove a transmission from the car.
	Prevention At installation of a transmission it is necessary to observe sequence of installation of arms. 1) Arm of support of the engine. 2) Top arm of a transmission. 3) Back arm. 4) Forward arm.

Installation

PERFORMANCE ORDER

	Establish on a forward part of a transmission the hydrotransformer and establish a transmission to the engine.
Prevention If the hydrotransformer to establish at first on the engine, at installation of a transmission the sealing ring of a transmission can be damaged.