Hyundai Accent

Repair and car operation

Hyundai Accent
+ 1. Maintenance instruction
+ 2. Engine
+ 3. Greasing system
+ 4. Cooling system
+ 5. Control, decrease in toxicity
+ 6. Fuel system
+ 7. Ignition system
+ 8. Coupling
- 9. Transmission
   + 9.1. Mechanical transmission
   - 9.2. Automatic transmission
      9.2.1. Specifications
      9.2.2. Control lamp of malfunctions (MIL)
      9.2.3. Diagnostic codes of malfunctions
      9.2.4. Reading of codes of malfunctions
      9.2.5. Check of pressure of transmission liquid
      9.2.6. Testing of collaboration of an automatic transmission and the engine on the motionless car (stall test)
      9.2.7. Check of level of liquid in an automatic transmission
      9.2.8. Check of operation of the lever of the selector
      9.2.9. Adjustment of the switch of indication of position of the lever of the selector
      9.2.10. Adjustment of the servo-driver of compulsory inclusion of a low gear
      9.2.11. Pressure adjustment in the highway
      9.2.12. Replacement of an oil sealing ring of a power shaft
      9.2.13. Replacement of a cable of a drive of a speedometer
      9.2.14. Removal and transmission installation
      9.2.15. Transmission repair
      9.2.16. Selector lever
      9.2.17. Adjustment of a cable of management
      9.2.18. Repair of the lever of the selector
+ 10. Axes and power shafts
+ 11. Suspension bracket
+ 12. Steering
+ 13. Brake system
+ 14. Body
+ 15. Central air
+ 16. Electric equipment
+ 17. Appendix
+ 18. Electroschemes

9.2.15. Transmission repair

The transmission represents very difficult unit and its repair it is necessary to make in a specialized workshop. Also at removal and installation of many details it is necessary to measure gaps and, if necessary, to adjust them for what use of the corresponding adjusting laying and washers is necessary. Not only that details of a transmission are absent on sale and they are necessary for ordering, they are still extremely expensive. If the transmission is faulty or works with strong noise, it is desirable to charge repair of a transmission to the expert or to replace a transmission that can cost cheaper considerably. However the part of malfunctions of a transmission can be eliminated without removal of a transmission from the car.

However, despite all difficulties, the skilled expert can make repair of a transmission and in house conditions. Thus it is necessary to have special tools and to perform work consistently, step by step noting the executed operations. At repair of a transmission it is necessary to use special flat-nose pliers for removal of lock rings, strippers for bearings, an inertial hammer, a set of punches, a micrometer and a hydraulic press.

Before removal of a transmission try to define most precisely malfunction of a transmission that further considerably will facilitate repair.