Hyundai Accent

Repair and car operation



Hyundai Accent
+ 1. Maintenance instruction
+ 2. Engine
+ 3. Greasing system
+ 4. Cooling system
+ 5. Control, decrease in toxicity
+ 6. Fuel system
+ 7. Ignition system
+ 8. Coupling
- 9. Transmission
   + 9.1. Mechanical transmission
   - 9.2. Automatic transmission
      9.2.1. Specifications
      9.2.2. Control lamp of malfunctions (MIL)
      9.2.3. Diagnostic codes of malfunctions
      9.2.4. Reading of codes of malfunctions
      9.2.5. Check of pressure of transmission liquid
      9.2.6. Testing of collaboration of an automatic transmission and the engine on the motionless car (stall test)
      9.2.7. Check of level of liquid in an automatic transmission
      9.2.8. Check of operation of the lever of the selector
      9.2.9. Adjustment of the switch of indication of position of the lever of the selector
      9.2.10. Adjustment of the servo-driver of compulsory inclusion of a low gear
      9.2.11. Pressure adjustment in the highway
      9.2.12. Replacement of an oil sealing ring of a power shaft
      9.2.13. Replacement of a cable of a drive of a speedometer
      9.2.14. Removal and transmission installation
      9.2.15. Transmission repair
      9.2.16. Selector lever
      9.2.17. Adjustment of a cable of management
      9.2.18. Repair of the lever of the selector
+ 10. Axes and power shafts
+ 11. Suspension bracket
+ 12. Steering
+ 13. Brake system
+ 14. Body
+ 15. Central air
+ 16. Electric equipment
+ 17. Appendix
+ 18. Electroschemes






9.2.18. Repair of the lever of the selector

Elements of the lever of the selector

1–solenoid of the lock of blocking;
2–switch of position N of the lever of the selector;
3–spring pin;
4–spring pin;
5–steel ball;
6–ball support;
7–spring;
8–hairpin;
9–selector lever;
10-adjusting cam of the lever;
11-core of the lever of the selector;
12-spring of the lever of the selector;
13-plug;
14-arm.

Check

PERFORMANCE ORDER
1. Check a clamp installation site on lack of wear.
2. Check a spring on absence of damages and elasticity loss.
3. Check a hairpin in the lever basis on lack of wear.

Assembly

PERFORMANCE ORDER
1. Grease a sliding part of the plug.

Greasing: SAE J310, NLGI No. 2

2. Put greasing in the places shown in drawing.

Greasing: SAE J310, NLGI No. 2