| 1. Merge transmission liquid from an automatic transmission. |
| 2. Remove the oil pallet. |
| 3. Remove the oil filter. |
|
4. Remove the sensor of temperature of transmission liquid. |
|
5. Press a clamp and extend a sealing ring of the electromagnetic valve. |
|
6. Remove valve knot, thus be careful, that it did not fall. |
| |
7. Turn the adjusting screw of the distributor so that pressure in the highway reached demanded value. Screw rotation clockwise leads to reduction of pressure and, on the contrary, counter-clockwise – to increase. Nominal pressure: 860–900 kPas
Pressure change at screw turn on 1 turn: 38 kPas
|
| 8. Check that the sealing ring is established on the top part of the case of the valve, in a place shown in drawing. |
| 9. Replace a sealing ring of the electromagnetic valve. |
|
10. Establish the valve case in a case and insert the socket of the electromagnetic valve into a case. Be convinced that the gear part of the socket is established how is shown in drawing. |
| 11. Tighten bolts of fastening of the case the moment of an inhaling of 10-12 N • m. |
| 12. Establish the oil filter. |
| 13. Establish new laying of the oil pallet and the oil pallet. |
| 14. Fill in demanded amount of transmission liquid in an automatic transmission. |
| 15. Check pressure in the highway. |