Hyundai Accent

Repair and car operation



Hyundai Accent
+ 1. Maintenance instruction
+ 2. Engine
+ 3. Greasing system
+ 4. Cooling system
+ 5. Control, decrease in toxicity
+ 6. Fuel system
+ 7. Ignition system
+ 8. Coupling
- 9. Transmission
   + 9.1. Mechanical transmission
   - 9.2. Automatic transmission
      9.2.1. Specifications
      9.2.2. Control lamp of malfunctions (MIL)
      9.2.3. Diagnostic codes of malfunctions
      9.2.4. Reading of codes of malfunctions
      9.2.5. Check of pressure of transmission liquid
      9.2.6. Testing of collaboration of an automatic transmission and the engine on the motionless car (stall test)
      9.2.7. Check of level of liquid in an automatic transmission
      9.2.8. Check of operation of the lever of the selector
      9.2.9. Adjustment of the switch of indication of position of the lever of the selector
      9.2.10. Adjustment of the servo-driver of compulsory inclusion of a low gear
      9.2.11. Pressure adjustment in the highway
      9.2.12. Replacement of an oil sealing ring of a power shaft
      9.2.13. Replacement of a cable of a drive of a speedometer
      9.2.14. Removal and transmission installation
      9.2.15. Transmission repair
      9.2.16. Selector lever
      9.2.17. Adjustment of a cable of management
      9.2.18. Repair of the lever of the selector
+ 10. Axes and power shafts
+ 11. Suspension bracket
+ 12. Steering
+ 13. Brake system
+ 14. Body
+ 15. Central air
+ 16. Electric equipment
+ 17. Appendix
+ 18. Electroschemes






9.2.4. Reading of codes of malfunctions

PERFORMANCE ORDER
With HI-SCAN scanner use
1. Switch off ignition.
2. Connect the HI-SCAN scanner to the diagnostic socket.
3. Include ignition.
4. On the HI-SCAN scanner consider codes of malfunctions.
5. Eliminate malfunction.
6. Erase diagnostic codes of malfunction.
7. Disconnect the HI-SCAN scanner from the diagnostic socket.
With voltmeter use
8. Switch off ignition.
9. Connect the voltmeter to contact of 1 diagnostic socket.
10. Connect a L-wire to contact 15 diagnostic sockets.
11. The sample of an exit is shown on the voltmeter.
12. Consider diagnostic codes of malfunctions.
13. Erase diagnostic codes of malfunctions.